5 Set DRV8825 Stepper Motor Driver Module Stepstick For 3D Printer Part Accessories | Обустройство дома

5 Set DRV8825 Stepper Motor Driver Module Stepstick For 3D Printer Part Accessories | Обустройство дома

Specification:

Brand new

Model: DRV8825

Maximum Supply Voltage: 45V

Six Different Step Resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step

Feature:

The DRV8825 stepper motor driver carrier is a breakout board for TI's DRV8825 micro stepping bipolar stepper motor driver.

Operates from 8.2~45V and can deliver up to approximately 1.5 A per phase without a heat sink or forced air flow (rated for up to 2.2 A per coil with sufficient additional cooling).

Simple step and direction control interface.

Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor's rated voltage to achieve higher step rates.

Built-in regulator (no external logic voltage supply needed).

Can interface directly with 3.3V and 5V systems.

Over-current and over-temperature protection, under-voltage lockout.

Short-to-ground and shorted-load protection.

Fine workmanship and good performance.

Easy to use.

Long service life.

Package included:

5 sets x Stepper Motor Driver Module

Note:

Please allow a little size errors due to manual measurement.

Item color displayed in photos may be showing slightly different on your computer monitor since monitors are not calibrated same.